Cisco Certified Field Technician CCT Practice Test 5

Cisco Certified Technician exam quiz questions

1 / 20

A switch is configured with VLANs, but devices in different VLANs cannot communicate. What is the most likely cause?

2 / 20

A technician wants to verify the Cisco IOS version and device uptime. What command should they use?

3 / 20

A router is not forwarding traffic to a specific subnet. What command should be used to verify the route?

4 / 20

A technician needs to back up a Cisco switch’s configuration to an external server. What command should they use?

5 / 20

A technician needs to configure a router to allow only specific hosts to access a network. What tool should they use?

6 / 20

A router has multiple paths to a destination network. What determines which path is chosen?

7 / 20

A technician wants to view the MAC addresses associated with each switch port. What command should they use?

8 / 20

A switch port is showing err-disabled status. What is the most likely cause?

9 / 20

A network technician needs to restore the factory settings on a Cisco router. What command should they use?

10 / 20

A router is not learning routes from an OSPF neighbor. What command should be used to verify OSPF neighbor relationships?

11 / 20

A technician needs to prevent unauthorized devices from connecting to a Cisco switch. What feature should be configured?

12 / 20

A Cisco router fails to load its IOS image during boot. What is the most likely reason?

13 / 20

A technician wants to check the interface status and assigned IP addresses on a router. What command should they use?

14 / 20

A network technician needs to reset the password on a Cisco router but does not have access to the current configuration. What process should they follow?

15 / 20

A router is not forwarding packets between directly connected networks. What command should be used to verify if IP routing is enabled?

16 / 20

A switch is experiencing high CPU utilization, and the technician suspects spanning-tree issues. What command should be used to verify spanning-tree status?

17 / 20

A company wants to remotely manage Cisco switches and routers over a secure connection. What protocol should they use?

18 / 20

A technician is diagnosing a network performance issue and suspects a broadcast storm. What command should be used to verify excessive broadcast traffic on a Cisco switch?

19 / 20

A technician needs to check the status of a serial link between two routers. The interface shows “up, line protocol down.” What is the most likely cause?

20 / 20

A technician is troubleshooting a Cisco switch that is unable to establish a trunk connection with another switch. Which command should be used to verify the trunking status of an interface?

Your score is

The average score is 0%

0%