Cisco Certified Field Technician CCT Practice Test 3

Cisco Certified Technician exam quiz questions

1 / 20

A technician needs to reset a router to factory default settings. What command should they use?

2 / 20

What is the function of Cisco Discovery Protocol (CDP)?

3 / 20

A technician needs to check the power supply status of a Cisco switch. What command should they use?

4 / 20

A technician is diagnosing an interface that shows as "administratively down." What is the most likely cause?

5 / 20

A router's configuration has been erased, and the device is now in setup mode. What should the technician do next?

6 / 20

A technician needs to check the VLAN assignments for all switch ports. What command should they use?

7 / 20

What command is used to manually bring up an interface that is administratively down?

8 / 20

A Cisco router’s default gateway needs to be set. Which command is used?

9 / 20

A technician needs to back up a switch’s configuration to a remote server. What protocol should be used?

10 / 20

What type of cable should be used to connect two switches directly?

11 / 20

A technician needs to verify the MAC addresses learned by a switch. What command should be used?

12 / 20

A technician needs to restart a Cisco switch remotely. What command should they use?

13 / 20

A technician needs to assign an IP address to a switch's VLAN 1 interface. What command should be used?

14 / 20

A technician is troubleshooting an issue where a switch is dropping packets. What command can help identify interface errors?

15 / 20

What Cisco feature helps prevent loops in Ethernet networks?

16 / 20

A technician suspects a routing issue between two Cisco routers. What command should be used first to check the routing table?

17 / 20

A Cisco switch’s interface is showing a large number of collisions. What could be a potential cause?

18 / 20

A technician needs to verify the current running configuration on a Cisco switch. What command should they use?

19 / 20

A Cisco router has been configured but is not responding to remote SSH access. What could be the issue?

20 / 20

A technician needs to establish a direct console connection to a Cisco switch but finds that the terminal emulator is not displaying any output. What is the most likely cause?

Your score is

The average score is 0%

0%