CCNP Security 300-710 SNCF Practice Test 1

CCNP Security 300-710 SNCF Practice Test 1 (Hard) - Secure Firewall Routed and Transparent Modes

CISCO CCNP Security Exam Logo

1 / 10

Which Secure Firewall Threat Defense deployment mode requires the device to act as a Layer 3 hop, with each interface assigned an IP address on a different subnet?

2 / 10

Which Secure Firewall Threat Defense deployment mode allows the firewall to be inserted into an existing network segment without requiring any readdressing of adjacent devices, since it functions as a Layer 2 bridge?

3 / 10

Which interface construct does transparent mode use to group two or more interfaces into a single Layer 2 bridge segment on Secure Firewall Threat Defense?

4 / 10

Which limitation applies to Secure Firewall Threat Defense when operating in transparent mode, compared to routed mode?

5 / 10

Which statement accurately describes how many bridge groups a single transparent-mode Secure Firewall Threat Defense device can support?

6 / 10

Which design consideration would most likely drive an organization to choose transparent mode over routed mode when inserting a Secure Firewall Threat Defense device into a data center segment?

7 / 10

Which traffic types are NOT supported for inspection when a Secure Firewall Threat Defense device is running in transparent mode?

8 / 10

Which of the following is a valid reason an administrator might convert an existing routed-mode Secure Firewall Threat Defense deployment to transparent mode during a network redesign?

9 / 10

Which mode change requires a Secure Firewall Threat Defense device to be reinitialized, since firewall mode (routed vs. transparent) is a fundamental deployment setting rather than a per-policy option?

10 / 10

Which statement correctly describes IPv6 support in transparent mode on Secure Firewall Threat Defense?

Your score is

The average score is 0%

0%